Re: [GMCnet] 1/2" tank vent steel tube source needed. [message #167687 is a reply to message #167682] |
Thu, 26 April 2012 22:14 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma:
|
Senior Member |
|
|
Robert Mueller wrote on Thu, 26 April 2012 21:50 | Steve,
Could you please go to the Parts Book 78Z page 12-2 and advise just which
tube you're looking for.
BTW when I was building ground support equipment for Project Apollo if I
needed a really straight piece of long tubing I'd clamp one end to something
solid and the other end to a come along and then "stretch" the tubing and it
came out straight.
Thanks,
Rob
|
Part ID #32 on page 12-2
A friend said he had some 1/2" aluminum tube, coil that I could use. I suspect your stretch straighting would work on that. Is AL tube suitable for use in a fuel system, especially with ethanol?
BTW the run from that tube (#32) up to the fuel filler, on my '74, is 1/2" rubber hose. It had a "factory installed" kink that reduced the effective diameter by more than half. I will be bending up a tube section to replace that rubber hose section.
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|