GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » muffler and placement
Re: [GMCnet] muffler and placement [message #159645 is a reply to message #159642] Wed, 08 February 2012 14:44 Go to previous messageGo to previous message
emerystora is currently offline  emerystora   United States
Messages: 4442
Registered: January 2004
Karma:
Senior Member
Yes, some O2 sensors are usually 2 wire. The heated one have 3 or 4 wires. These have a heating element built in so that they come up to operating temperature more quickly.

The sensors only work effectively when heated to approximately 316 °C (600 °F), so most newer lambda probes have heating elements encased in the ceramic that bring the ceramic tip up to temperature quickly. Older probes, without heating elements, would eventually be heated by the exhaust, but there is a time lag between when the engine is started and when the components in the exhaust system come to a thermal equilibrium. The length of time required for the exhaust gases to bring the probe to temperature depends on the temperature of the ambient air and the geometry of the exhaust system. Without a heater, the process may take several minutes.

So, if you place the sensor farther from the engine it might not work well unless its a heated sensor.

Emery Stora

On Feb 8, 2012, at 1:32 PM, sgltrac wrote:

>
>
> Emery,
> A heated O2 sensor??
> --
> Sully
> 77 Royale basket case.
> Future motorhome land speed record holder(bucket list)
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Emery Stora
77 Kingsley
Santa Fe, NM


_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Exhaust Manifold Gasket Replacement
Next Topic: [GMCnet] Introduction
Goto Forum:
  


Current Time: Tue May 21 21:06:41 CDT 2024

Total time taken to generate the page: 0.00922 seconds