Re: [GMCnet] Installing Grease Zerks For Front Wheel Bearings [message #124298 is a reply to message #124293] |
Mon, 02 May 2011 18:35 |
shawnee
Messages: 422 Registered: February 2004 Location: NC
Karma:
|
Senior Member |
|
|
ahamilto wrote on Mon, 02 May 2011 19:03 | I read those some time ago and that info is what prompted my question. I generally pump more than "a couple" of times on the gun, and want to fill that cavity without blowing out the inner seals. Maybe I will just take out another mortgage on the house and get a Hubler 1-ton front end. Or leave the money pit parked in the driveway for a few more years while I save up for one.
|
If you move the axle back far enough you will clear the grease seal and you can pump all you want and get grease out without pushing the seal out. I usually pump enough to get new grease coming out. I do it every fall after the last rally. If you do not push the axle out far enough you can push the seal out of place.
Gene Dotson
74 Canyonlands
www.bdub.net/Motorhome_Enhancements New Windows and Aluminum Radiators
|
|
|