GMCforum: GMCnet » Engine water temp sender location.

Home » Public Forums » GMCnet » Engine water temp sender location.

Show: Today's Messages :: Polls :: Message Navigator

Engine water temp sender location. [message #322334]

Sat, 19 August 2017 09:50

Scott Nutter

Messages: 782
Registered: January 2015
Location: Houston/San Diego

Karma:

Senior Member

I am in the process of hooking up a new engine water temperature gauge.
The manufacture, maxxtow, recommends to put the sending unit in the radiator. I have the aluminum radiator and it has a port to accept the sending unit.
Our stock system has the sending unit in the intake manifold.

Is there a advantage in having the sending unit in the rad? Is the intake manifold still the best location?
Or run the new gauge with the probe in the rad, and leave the stock gauge as is?

Opinions? Recommendations?
Thanks, Scott

Scott Nutter 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI Houston, Texas

Report message to a moderator

[Message index]

		Engine water temp sender location. By: Scott Nutter on Sat, 19 August 2017 09:50
		Re: [GMCnet] Engine water temp sender location. By: Emery Stora on Sat, 19 August 2017 11:19
		Re: [GMCnet] Engine water temp sender location. By: USAussie on Sat, 19 August 2017 15:51
		Re: Engine water temp sender location. By: Scott Nutter on Sat, 19 August 2017 17:55

Previous Topic:	[GMCnet] Than you all for your help. We learn a lot here. This is a link to the renovation pictures if you care to see them.
Next Topic:	[GMCnet] Cockpit seats

Goto Forum:

-=] Back to Top [=-

Current Time: Wed May 15 03:50:47 CDT 2024

Total time taken to generate the page: 0.00536 seconds