GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Kendra is looking for drawings for GMC cabinets
[GMCnet] Kendra is looking for drawings for GMC cabinets [message #370094] Fri, 08 July 2022 10:28 Go to next message
Matt Colie is currently offline  Matt Colie   United States
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma: 7
Senior Member
Copied from GMC Motorhomes forum.

Yesterday at 11:18 PM

Short term I'm fine with the original particle board cabinets. A bit rough but they get the job done.

Longer term I'd like to replace all the particle board with higher quality wood cabinets and fittings - in most cases following original measurements
and layout. I don't have the skills to build these, so I'll need to take a set of drawings to a cabinet shop or boat interior specialist.

Has anyone found or created a detailed set of cabinet drawings based on the original GM 26' set?
I searched here, GMCMH Photos, GMCMI folders, etc.

thanks!
-Kendra
Kendra Fowles, Seattle, 1978 Kingsley

I these are in the files somewhere, I will forward the location to Kendra.

Matt
--
Matt & Mary Colie - Chaumi??re -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:



Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
Re: [GMCnet] Kendra is looking for drawings for GMC cabinets [message #370136 is a reply to message #370094] Sat, 16 July 2022 06:11 Go to previous message
PeteSr is currently offline  PeteSr   Romania
Messages: 26
Registered: October 2020
Location: New Port Richey, FL
Karma: 0
Junior Member
Matt,

I am renovating the interior of my 26' 1978 Eleganza II. If you find any cabinet drawings, would you please also send me their location? Or post it in this conversation. Thanks!

Regards,
Pete P.


78 Eleganza II
Stock 403 w/ Carb
Single Cinnebar bags
6kW Onan

[Updated on: Sat, 16 July 2022 06:11]

Report message to a moderator

Previous Topic: [GMCnet] Fwd: Assistance Needed !
Next Topic: [GMCnet] Tach wire
Goto Forum:
  


Current Time: Sat May 04 08:58:07 CDT 2024

Total time taken to generate the page: 0.00467 seconds