| Remote Onan primer switch [message #367333] |
Wed, 27 October 2021 14:45  |
Bruce Hart
Messages: 1500
Registered: October 2011
Location: La Grange, Wyoming
Karma: 5
|
Senior Member |
|
|
Installed a primer switch on the inside remote panel. Activated the primer switch, start switch and Onan fires right up. When I release the prime switch the Onan dies. I have compared my wiring to the write up on following article:
http://gmcmotorhome.info/onan.htm
Thinking that it could be a bad start/stop I replaced it and got same results.
Any ideas from the crowd?
Powered the primer switch from exterior light switch just inside door(Purple wire).
Remote Onan switch has a run meter and no battery condition meter. On the control board # 5 pin has a wire connected to it and not to #6 which manual and tech write up suggests.
Power Drawer Operators Manual page 8 and 9
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
|
| Re: Remote Onan primer switch [message #367334 is a reply to message #367333] |
Wed, 27 October 2021 16:49  |
 |
Matt Colie
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
Bruce,
That Prime button by-passes all the system safeties the Onan has. It could be that the LOP switch isn't making up or the flywheel isn't powering the board. Those are the two most likely, it seems. They are easy to test out at the control board. Nothing has to be defective, just a bad (40+yo) connection can stop it from running.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
