GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Electrical gremlins
Electrical gremlins [message #326037] Wed, 15 November 2017 15:10 Go to next message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma: -74
Senior Member
I had two gremlins pop up recently, the turn/hazard flasher stopped flashing and the timed warning light for setting the Electro-Level became flaky. I replaced the warning control with the PC setup I've mentioned earlier, just like the previous coach. I've an electronic flasher due Friday for the turn/hazard. 8 bucks from Amazon Prime, vs 20+ from AutoZone and Advanced.. Both of them failed in that the heater for the bimetal failed. Not uncommon after 40 years, but a PIA to find them behind the dash.
My roof antenna quit and I identified a short in the coax leading from it to the power injector, so for want of the time to run a new one, I've been using an outboard coax in the toll window to the injector - works fine but requires a climb up the ladder at setup and knockdown, and it looks tacky. We be replacing the wire - shorted coax is very uncommon, I suspect it's pinched somewhere.
I've gotten tired of the lack of domelights up front, so I'm tackling them as well. First, disassemble the switches and crocus cloth the contacts. Fortunately they're made to disassemble. A bit of alcohol, a bit of crocus to polish, and the switches now work. A look at the diagram shows the three position switch is OFF, ON, and SWITCHED. Switched is connected to the headlight switch like cars of the day - turn the knob to full bright and it switches the dome on by grounding it. As luck would have it, the door switch also grounds, with a wire 'for use by the upfitter'. Well, mine now runs to the headlight switch. In the center position, the lamp is off. Go one way, it comes on. Go the other way and the door or the headlight knob turns it on. No more getting in and fumbling in the dark to get some light up front!. Try it, you'll like it.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
Re: Electrical gremlins [message #326040 is a reply to message #326037] Wed, 15 November 2017 16:21 Go to previous messageGo to next message
tphipps is currently offline  tphipps   United States
Messages: 3005
Registered: August 2004
Location: Spanish Fort, AL
Karma: 9
Senior Member
Johnny, You may find the upfitter went from coax to 300 ohm somewhere in the ceiling. Avion did that on mine. Never did find the other end of the 300 ohm lead. Might be a bit of trouble, but replace the whole length with RG6.
Tom


2012 Phoenix Cruiser model 2552 KA4CSG
Re: Electrical gremlins [message #326045 is a reply to message #326037] Wed, 15 November 2017 19:59 Go to previous messageGo to next message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma: -74
Senior Member
No, this'n is a GMC upfit - Eleganza II. I think a PO or two back had the Winegard installed, it's the smaller of the two and the cable is routed into the icebox vent and then down to the frame and back up in front of the passenger seat behind the trim panel.. I figure it's crimped someplace along the way. Actually, if you use baluns, 300 Ohm wouldn't hurt anything. It's less lossy than RG, but probably the gain wouldn't overcome the loss from two baluns. The coach is fitted with two TVs, the roof antenna, and a cablevision connection coiled up in the power bay. I've a complete spare Winegard in the box, I suspect the switch/power injector is in there someplace. The switch on the one in the coach is busted. It's fitted to the glovebox door, I'll leave the new one there since there's a large hole in the door for it. I have plenty of RG6 kicking around. Since the amplifier is in the antenna itself, I may us RG-59 instead - it has a tighter bend radius and it's easier to get through tight places. Being that it's an amplified signal, the loss difference at UHF for ten - 12 feet of it isn't going to be an issue. Couple tenths of a dB at best I'd think.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
Re: Electrical gremlins [message #326114 is a reply to message #326037] Fri, 17 November 2017 15:29 Go to previous message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma: -74
Senior Member
Voila! We be dome lights.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
Previous Topic: [GMCnet] Work platform
Next Topic: Can booster hold vacuum and not boost
Goto Forum:
  


Current Time: Thu Mar 28 09:56:53 CDT 2024

Total time taken to generate the page: 0.01558 seconds