Back panel behind bath under sink compartment? [message #305292] |
Thu, 11 August 2016 15:05 |
LarryInSanDiego
Messages: 336 Registered: September 2006
Karma: 0
|
Senior Member |
|
|
The under sink compartment in the bath has no back whatsoever. I see the factory sprayed on insulation and the water heater to the right (rear). It's angled somewhat and it seems like there should have been some sort of removable or block off panel back there, but I see no evidence of such. Perhaps my early VIN hadn't yet been fitted with one or does someone have one for sale I could get? It just screams "unfinished". The only other GMC I have seen under the sink was a '78 not outfitted from GMC. Mine was, so that's obviously not an appropriate comparison. Thanks in advance.
Larry Engelbrecht
San Diego, CA
'73 26' ex-Glacier
TZE063V100319 03/07/73
[Updated on: Thu, 11 August 2016 15:09] Report message to a moderator
|
|
|
|
Re: Back panel behind bath under sink compartment? [message #306679 is a reply to message #305292] |
Wed, 07 September 2016 18:25 |
|
SeanKidd
Messages: 747 Registered: June 2012 Location: Northern Neck Virginia
Karma: 4
|
Senior Member |
|
|
Larry, my bath module is the same, the whole back is open to the wheel well area, plumbing, water heater. Remember our coaches are siblings...btw when I custom fit Lowes cabinets in the kitchen, I had to remove the backs. I used correlated plastic sheeting looks like cardboard, but plastic to create new backs and seal the cabinets so I wouldn't lose things back there. I used metal duct tape to hold it all together.
Sean and Stephanie
73 Ex-CanyonLands 26' #317 "Oliver"
Hubler 1-Ton, Quad-Bags, Rear Disc, Reaction Arms, P.Huber TBs, 3.70:1 LSD Honda 6500 inverter gen.
Colonial Travelers
|
|
|