Re: [GMCnet] Installing Grease Zerks For Front Wheel Bearings [message #218430 is a reply to message #124333] |
Thu, 15 August 2013 08:49 |
rjw
Messages: 697 Registered: September 2005
Karma: 4
|
Senior Member |
|
|
Robert Mueller wrote on Tue, 03 May 2011 00:15 |
To grease the front wheel bearings on a GMC that has zerk fittings
installed:
I've typed this from memory and if I've over looked anything or screwed it
up PLEASE correct me.
Regards,
Rob M.
|
As a last step, don't you use a q-tip to clean up the excess grease that oozes out? Otherwise you might have a mess later. Dave Lenzi told me that you did that.
Richard
76 Palm Beach
SE Michigan
www.PalmBeachGMC.com
Roller Cam 455, TBI+EBL, 3.42 FD, 4 Bag, Macerator, Lenzi (brakes, vacuum system, front end stuff), Manny Tranny, vacuum step, Tankless + OEM water heaters.
|
|
|
Re: [GMCnet] Installing Grease Zerks For Front Wheel Bearings [message #218579 is a reply to message #218430] |
Fri, 16 August 2013 10:08 |
|
USAussie
Messages: 15912 Registered: July 2007 Location: Sydney, Australia
Karma: 6
|
Senior Member |
|
|
Yep!
That was Rev 1 that never got incorporated! ;-)
Regards,
Rob M.
-----Original Message-----
From: RJW
As a last step, don't you use a q-tip to clean up the excess grease that oozes out? Otherwise you might have a mess later. Dave
Lenzi told me that you did that.
--
Richard
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Regards,
Rob M. (USAussie)
The Pedantic Mechanic
Sydney, Australia
'75 Avion - AUS - The Blue Streak TZE365V100428
'75 Avion - USA - Double Trouble TZE365V100426
|
|
|