GMCforum: GMCnet » [GMCnet] Rear License Plate Light Assembly

Home » Public Forums » GMCnet » [GMCnet] Rear License Plate Light Assembly

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Rear License Plate Light Assembly [message #366708]

Sat, 11 September 2021 13:01

Anonymous

Todd is tracing down a short while installing a Furrion rear and side cameras with lights and the rear license plate light assembly is corroded - so maybe the same for the front.

Do any of you have a rear license plate assembly that is in sort of good shape? Same for the front.

We are also replacing the older clearance lights with LED clearance lights. So all lights are now LED.

1976 Birchaven (The Aluminum Falcon) should be flying by Oct.

Virgil
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Report message to a moderator

Re: [GMCnet] Rear License Plate Light Assembly [message #366709 is a reply to message #366708]

Sat, 11 September 2021 13:50

JohnL455

Messages: 4447
Registered: October 2006
Location: Woodstock, IL

Karma: 12

Senior Member

For rear light you can cut sheet metal in that boomerang shape and install a trailer plate light in it such as from etrailer. This is what Cinnabar does.

John Lebetski
Woodstock, IL
77 Eleganza II

Report message to a moderator

Re: [GMCnet] Rear License Plate Light Assembly [message #366759 is a reply to message #366708]

Mon, 13 September 2021 14:31

6cuda6

Messages: 975
Registered: June 2019

Karma: -6

Senior Member

I managed to source a nice used one off Ebay but if i had to do it again i would just do as John said.

Rich Mondor, Brockville, ON 77 Hughes 2600

Report message to a moderator

Previous Topic:	[GMCnet] Brake Bleeding with Air Brake Compressor attached to brake proportioning valve (?)
Next Topic:	[GMCnet] Re: Distributor seized up, ( DATA )

Goto Forum:

-=] Back to Top [=-

Current Time: Sat May 11 21:14:46 CDT 2024

Total time taken to generate the page: 0.01433 seconds