|
|
|
|
| Re: [GMCnet] Looked inside the engine water pump while installed. It's correct [message #329277 is a reply to message #329275] |
Mon, 19 February 2018 06:57   |
Dave Stragand
Messages: 307
Registered: October 2017
Karma: 0
|
Senior Member |
|
|
I don’t think it’s a good idea to cut the radiator. Cutting the support might help though. :)
> On Feb 19, 2018, at 12:41 AM, Bob Dunahugh wrote:
>
> Ran the test below. Then started to pull the radiator. 90 minutes. Done. It was mentally harder to do then doing it. Cutting the radiator should make it simpler to put it in. Bob Dunahugh 78 Royale
>
>
> ________________________________
> From: Bob Dunahugh
> Sent: Sunday, February 18, 2018 9:53 PM
> To: gmclist@list.gmcnet.org
> Subject: Looked inside the engine water pump while installed. It's correct
>
>
> Put my inspection camera in the right 3/4" heater hose connection. It's the top right hose connection of the water pump. Rotated the pump shaft while counting the 6 blades inside. Just wasn't happy till I looked for myself. Bob Dunahugh 78 Royale
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
1978 Transmode (403)
Pittsburgh, PA
|
|
|
|
|
|
| Re: [GMCnet] Looked inside the engine water pump while installed. It's correct [message #329284 is a reply to message #329283] |
Mon, 19 February 2018 11:11 |
emerystora
Messages: 4442
Registered: January 2004
Karma: 13
|
Senior Member |
|
|
I’m sure that most of us were bright enough to know that.
Emery Stora
> On Feb 19, 2018, at 10:08 AM, Bob Dunahugh wrote:
>
> (cutting radiator). I meant to say cutting radiator support. Bob Dunahugh
>
>
> ________________________________
> From: Bob Dunahugh
> Sent: Sunday, February 18, 2018 11:40 PM
> To: gmclist@list.gmcnet.org
> Subject: RE: Looked inside the engine water pump while installed. It's correct
>
>
> Ran the test below. Then started to pull the radiator. 90 minutes. Done. It was mentally harder to do then doing it. Cutting the radiator should make it simpler to put it in. Bob Dunahugh 78 Royale
>
>
> ________________________________
> From: Bob Dunahugh
> Sent: Sunday, February 18, 2018 9:53 PM
> To: gmclist@list.gmcnet.org
> Subject: Looked inside the engine water pump while installed. It's correct
>
>
> Put my inspection camera in the right 3/4" heater hose connection. It's the top right hose connection of the water pump. Rotated the pump shaft while counting the 6 blades inside. Just wasn't happy till I looked for myself. Bob Dunahugh 78 Royale
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
