|
|
| Re: [GMCnet] How to adjust Park/Neutral Safety Switch? [message #329267 is a reply to message #329266] |
Sun, 18 February 2018 16:35   |
jimk
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma: 9
|
Senior Member |
|
|
Armand,
Follow the rod down to the swithd, there you'll find slotted holes holding
the switch, loosen and move up or down.
On Sun, Feb 18, 2018 at 1:40 PM, Armand Minnie wrote:
> Can anyone point me at instructions for adjusting the Park/Neutral Safety
> Switch?
> --
> Armand Minnie
> Marana, AZ
> '76 Eleganza II TZE166V103202
> http://www.minniebiz.com
> http://www.gmcws.org
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
|
| Re: How to adjust Park/Neutral Safety Switch? [message #329268 is a reply to message #329266] |
Sun, 18 February 2018 16:49 |
C Boyd
Messages: 2629
Registered: April 2006
Karma: 18
|
Senior Member |
|
|
After scotching the coach and making sure the shifter linkage and bushings are in the detents correctly cut the key on without engine running and put transmission lever in reverse. Adjust switch by loosening 2 screws and moving sideways till backup lights are on solidly and tighten screws. Check for starting in neutral and park only.
armandminnie wrote on Sun, 18 February 2018 16:40Can anyone point me at instructions for adjusting the Park/Neutral Safety Switch?
C. Boyd
76 Crestmont
East Tennessee
|
|
|
|
| Re: How to adjust Park/Neutral Safety Switch? [message #329269 is a reply to message #329266] |
Sun, 18 February 2018 17:46 |
Ken Burton
Messages: 10030
Registered: January 2004
Location: Hebron, Indiana
Karma: 10
|
Senior Member |
|
|
You read Chucks directions and they are spot on. After everything is set up correctly loosen to screws and with the engine not running move the switch slightly until the back up lights turn on. I do it after dark so I can see them on from inside the coach.
I actually have mine adjusted so if I hold up on the gear shift in reverse I have back up lights and if I hold down I have no lights. I did this because I have some super bright LED back up lights and do not want to blind someone or bother someone in a campground late a night.
It is a 5 minute job to adjust the switch when everything else in the gear shift linkage is set up correctly.
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
|
|
|
|
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
