Power Steering Pump Pulley [message #324871] |
Thu, 12 October 2017 17:32 |
Ray Erspamer
Messages: 1707 Registered: May 2007 Location: Milwaukee Wisconsin
Karma: -3
|
Senior Member |
|
|
Good Afternoon
I'm in need of a new Power Steering Pump Double Pulley. The OEM pulley is 6 1/2" diameter and all I can find is a Dorman 300-121 which is a 5 3/4" diameter.
The pulley is pressure fit. I used the proper puller to remove it and now after purchasing 2 different new pumps the old pulley just slips right on to the shaft with no friction at all. I bought the Dorman and the fit is tight and correct but the pulley is the wrong diameter.
Any help is appreciated.
Thanks
Ray Erspamer
Ray Erspamer
78 GMC Royale Center Kitchen
403, 3.70 Final Drive
Holley Sniper Quadrajet EFI System,
Holley Hyperspark Ignition System
414-484-9431
|
|
|
|
|
Re: [GMCnet] Power Steering Pump Pulley [message #324914 is a reply to message #324888] |
Fri, 13 October 2017 17:04 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
Ray,
I currently have two power steering pumps on the floor of my barn. One is 6-1/2 and that one is the older nut fastened the newer that needs the puller that locks into a grove seems to be about 6-3/8 but I was having a hard time and didn't feel like walking across the shop to get a real measuring device. Both are very rusty. You are welcome to both or either if I can get them loose. Just let me know.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|