| Windshield wipers actuator bracket replacement [message #321094] |
Tue, 25 July 2017 17:49  |
|
|
A couple years ago my coach was vandalized by a couple f@#kheads and they literally broke the passenger side wiper arm clean off snapping the stud that it mounts to. Now granted it doesnt rain much here in soCal but I would like to fix this. Is it possible to install a new stud in the old bracket or will the whole thing require replacement? I'm assuming that bracket was used on other GM vans of the same period so maybe it is possible to source one from them? Any help is appreciated as always.
Shan
73 Canyon Lands, (a.k.a. The Yellow Submarine) West Los Angeles CA
|
|
|
|
| Re: [GMCnet] Windshield wipers actuator bracket replacement [message #321112 is a reply to message #321094] |
Tue, 25 July 2017 20:58  |
Ken Henderson
Messages: 8726
Registered: March 2004
Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Shan,
I'm pretty sure the entire stud bracket, and the attached linkage are
attached to the underside of the horizontal portion of the firewall just
below the windshield -- 2 or 3 vertical hex headed bolts, 1/2" or 9/16".
It's very unlikely that you'll get a replacement anywhere except from a
junked GMC, but that should be pretty easy to find since few of them are
replaced. Someone here may volunteer to help, or you can call one of our
usual suppliers. If your signature block included more information, like
coach model and your city, we might guide you to closest support.
Ken H.
On Tue, Jul 25, 2017 at 6:49 PM, Shan Rose wrote:
> A couple years ago my coach was vandalized by a couple f@#kheads and they
> literally broke the passenger side wiper arm clean off snapping the stud
> that it mounts to. Now granted it doesnt rain much here in soCal but I
> would like to fix this. Is it possible to install a new stud in the old
> bracket
> or will the whole thing require replacement? I'm assuming that bracket was
> used on other GM vans of the same period so maybe it is possible to source
> one from them? Any help is appreciated as always.
>
> Shan
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
|
|
|
|
|
|
|
| Re: [GMCnet] Windshield wipers actuator bracket replacement [message #321130 is a reply to message #321121] |
Wed, 26 July 2017 05:54 |
Bruce Hart
Messages: 1500
Registered: October 2011
Location: La Grange, Wyoming
Karma: 5
|
Senior Member |
|
|
I recently had to replace that wiper arm and linkage due to a heavy snow
fall that broke the wiper stud. Two 5/16" bolts hold the bracket to the
cowling and three 10-32 bolts hold arm to that bracket. I was able to
force the old linkage out but because of the heater box I had to remove the
thee 10-32 screws to install the linkage arm. Not much room under there to
get at screws.
On Tue, Jul 25, 2017 at 8:32 PM, Ken Henderson
wrote:
> If MIguel has a parts coach around, it will almost certainly have that part
> on it. It's not likely to show a part number and it won't mean anything to
> anyone anyway.
>
> Ken H.
>
>
> On Tue, Jul 25, 2017 at 10:25 PM, Shan Rose wrote:
>
>> ok fixed. :) I'll remove the linkage later and see if I can get a P/N off
>> of it...
>> --
>> 73 Canyon Lands, (a.k.a. The Yellow Submarine) West Los Angeles CA
>>
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Bruce Hart
1976 Palm Beach
Milliken, Co
GMC=Got More Class
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Re: Windshield wipers actuator bracket replacement [message #321201 is a reply to message #321195] |
Fri, 28 July 2017 08:09 |
Jp Benson
Messages: 649
Registered: October 2011
Location: Fla
Karma: 2
|
Senior Member |
|
|
C Boyd wrote on Thu, 27 July 2017 21:36You have 2 electric wiper motors? One on each side?.?
That's what I have. I used the original pivot shafts but had to redrill the arms to match the drive arms on the motors. It's good to know that JimK has new pivot shafts.
JP
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
I'll remove the linkage later and see if I can get a P/N off of it...