One ton inner CV boot [message #317368] |
Wed, 10 May 2017 20:52 |
Hal StClair
Messages: 971 Registered: March 2013 Location: Rio Rancho NM
Karma: -12
|
Senior Member |
|
|
Anyone have the number for the inner CV boot from a Manny one ton?
Thanks for any help.
Hal
"I enjoy talking to you. Your mind appeals to me. It resembles my own mind, except you happen to be insane."
1977 Royale 101348,
1977 Royale 101586, Diesel powered,
1974 Eagle Bus 45',w/slideout,
Rio Rancho, NM
|
|
|
Re: [GMCnet] One ton inner CV boot [message #317370 is a reply to message #317368] |
Wed, 10 May 2017 22:14 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Hal,
/
I've got a couple of spares; I'll try to remember to check them for numbers
tomorrow.
However, a good application guess would be a 96 Chevy 3/4 t. Suburban 4wd.
Ken H.
On Wed, May 10, 2017 at 9:52 PM, Hal StClair
wrote:
> Anyone have the number for the inner CV boot from a Manny one ton?
> Thanks for any help.
> Hal
> --
> 1977 Royale 101348,
>
> 1977 Royale 101586, Diesel powered,
>
> 1975 Eleganza II, 101230
>
> 1974 Eagle Bus 45',w/slideout
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
Re: [GMCnet] One ton inner CV boot [message #317435 is a reply to message #317368] |
Fri, 12 May 2017 09:23 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Hal,
The boots I have from Manny are Interparts BT-257. For most GM
applications, that's specified as Inner; for some, Outer. Without being
able to check the numbers on the boots installed on Manny's axles, they
appear to be the same at each end. Interparts has a PDF on Google for
their boots.
Ken H.
On Wed, May 10, 2017 at 9:52 PM, Hal StClair
wrote:
> Anyone have the number for the inner CV boot from a Manny one ton?
> Thanks for any help.
> Hal
> --
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
Re: [GMCnet] One ton inner CV boot [message #317445 is a reply to message #317435] |
Fri, 12 May 2017 11:37 |
Hal StClair
Messages: 971 Registered: March 2013 Location: Rio Rancho NM
Karma: -12
|
Senior Member |
|
|
Thank you for the numbers Ken. Interparts aren't common around here but are a better fit for the reduced clearance outboard CV. They are a little smaller OD and clear the ball joint bolts a little better. I picked up a Moog 9470 which is listed for both sides/ends. Should know later today how it works.
Thank you again. Hal
"I enjoy talking to you. Your mind appeals to me. It resembles my own mind, except you happen to be insane."
1977 Royale 101348,
1977 Royale 101586, Diesel powered,
1974 Eagle Bus 45',w/slideout,
Rio Rancho, NM
|
|
|