Air fitting at Leveling Valve [message #315826] |
Tue, 11 April 2017 08:54 |
Jon payne
Messages: 495 Registered: May 2008
Karma: 1
|
Senior Member |
|
|
Guys,
The fitting that attaches to the leveling valve (driver side) broke off, see below picture. I'm looking for ideas on how to make this repair. The tee fitting is easy to replace with a new one but not sure what thread size I need to get for the fitting on the leveling valve. The tee fitting I will get will be the push to connect type.
Any know what size fitting is on the leveling valve?
http://tinyurl.com/lnsqjqx
Jon Payne
76 Palm Beach
Westfield,IN
|
|
|
Re: Air fitting at Leveling Valve [message #315831 is a reply to message #315826] |
Tue, 11 April 2017 11:34 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
Jon,
Your picture did not make it and neither did the link. That's OK because pictures posted to the forum cannot be seen by the e-mail half.
I suggest you tell us which fitting broke and maybe Dave Lenzi can fix it for you.
I think JimK has replacements that are bolt-in or at least have instructions.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|