Re: [GMCnet] GMC Strikes Again! [message #370613 is a reply to message #370611] |
Sun, 02 October 2022 19:18 |
JohnL455
Messages: 4447 Registered: October 2006 Location: Woodstock, IL
Karma:
|
Senior Member |
|
|
Yeah, seat it at 30 ft/lbs turning drum. Stop, loosen nut, tighten with 2 fingers. Pin it in whichever hole set lines up. If neither hole set lines up, LOOSEN the nut til one hole set lines up and pin it. That amount will be no more than 1/2 of one castellation as the holes are in alternating 1/2 castellation increments.
Everyone should know this that drives a GMC.
John Lebetski
Woodstock, IL
77 Eleganza II
[Updated on: Sun, 02 October 2022 19:19] Report message to a moderator
|
|
|