GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Good by Dan
Re: Good by Dan [message #269480 is a reply to message #269468] Mon, 12 January 2015 13:03 Go to previous messageGo to previous message
Ken Burton is currently offline  Ken Burton   United States
Messages: 10030
Registered: January 2004
Location: Hebron, Indiana
Karma:
Senior Member
I'm not good at good byes and funerals. If I can get out of attending a funeral I will do so. In this case I felt I had to go and wanted to go. Dan was a very good friend.

I am convinced that Teri planned and ran this funeral even though I have no confirmation of that. As I said before it was the best funeral I have ever attended. I normally would not rate a solemn occasion like a funeral, but this one was exceptional and it was a fitting memorial to Dan, his life, and to his extended family.

Many times when Dan and I were communicating during his treatments I would ask Dan a question, and he would say "I do not know. Teri handles that." Or if I would give him a piece of information and he would say "I'll pass that on to Teri." Teri is a very strong and dedicated person and when it came to Dan no one could have better. We all need someone like her in our lives. Unfortunately there are not that many Teri's to go around in this world.

So you have had the pleasure of knowing one (place your adjective here) couple. I just hope that Teri has time off now to get some rest. I did not ask her what she planned GMC wise going forward. When I left there I assumed that we will hear more from from her in the future. I know Laurie and I will try to keep in contact with her. The GMC thing with them was not just Dan. It was and still is Dan and Teri or Teri and Dan. Why does the male usually get listed first?


Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: "RPM" aluminum manifold manufacture and cost
Next Topic: [GMCnet] Bodypads on a 78'
Goto Forum:
  


Current Time: Sun Jun 02 04:12:24 CDT 2024

Total time taken to generate the page: 0.73344 seconds