GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Onan Remote Wiring
Re: [GMCnet] Onan Remote Wiring [message #318240 is a reply to message #318238] Tue, 30 May 2017 19:47 Go to previous messageGo to next message
A Hamilto is currently offline  A Hamilto   United States
Messages: 4508
Registered: April 2011
Karma: 39
Senior Member
Ken Henderson wrote on Tue, 30 May 2017 18:56
A.,
I don't know what Onan schematic you're looking at, 'cause the one I see in the Onan manual, page 30, shows pins 6 & 9 directly connected to the fuel solenoid, the fuel pump, and the coil. I posted a very roughly hi-lited copy at:
https://drive.google.com/file/d/0B3XquSIYjDleZjRiOEwyN1NxeXM/view?usp=sharing

Have you found a different version?

Ken H.

Apparently. I Have a 6k manual, but the resolution is too poor to make out the pin numbers. What manual do you have that shows the run indicator lamp (and/or Hobbs meter) of the remote panel wiring connected anywhere but pin 6?

From the 4k ops and parts manual, page 11, figure 10:

http://www.gmcmhphotos.com/photos/data/10/Onan_Control_Board_Schematic.jpg

And page 8, figure 6:

http://www.gmcmhphotos.com/photos/data/10/medium/Onan_Remote_Control_Switch.jpg

And page 9, figure 8:

http://www.gmcmhphotos.com/photos/data/10/medium/Onan_Deluxe_Remote_Control.jpg
Re: [GMCnet] Onan Remote Wiring [message #318241 is a reply to message #318240] Tue, 30 May 2017 19:53 Go to previous messageGo to next message
A Hamilto is currently offline  A Hamilto   United States
Messages: 4508
Registered: April 2011
Karma: 39
Senior Member
Of course, there is this one that shows pin 6 and 9 being electrically identical (but the remote panel still connects to pin 6):

I really think the run indicator on the remote panel and the Hobbs meter should be connected to pin 6 so that it is independent of the revision of board you are using.

http://www.gmcmhphotos.com/photos/data/10/Onan_Schematic.jpg
Re: [GMCnet] Onan Remote Wiring [message #318242 is a reply to message #318240] Tue, 30 May 2017 20:05 Go to previous messageGo to next message
Ken Henderson is currently offline  Ken Henderson   United States
Messages: 8726
Registered: March 2004
Location: Americus, GA
Karma: 9
Senior Member
Ah Ha! We've found it! I don't have time now to do the research to sort
it all out, but there ARE differences in the manuals!

The schematic you show IS different than that I referred to. And yours is
obviously the one from which I drew "my" version because it shows (6)
connected as I just "corrected" to agree with the other schematic. :-(

I'll try to get back into this tomorrow and identify which manuals have
which versions.

Ken H.


On Tue, May 30, 2017 at 8:47 PM, A. wrote:

> Ken Henderson wrote on Tue, 30 May 2017 18:56
>> A.,
>> I don't know what Onan schematic you're looking at, 'cause the one I see
> in the Onan manual, page 30, shows pins 6 & 9 directly connected to the
>> fuel solenoid, the fuel pump, and the coil. I posted a very roughly
> hi-lited copy at:
>> https://drive.google.com/file/d/0B3XquSIYjDleZjRiOEwyN1NxeXM/
> view?usp=sharing
>>
>> Have you found a different version?
>>
>> Ken H.
>
> Apparently. I Have a 6k manual, but the resolution is too poor to make out
> the pin numbers. What manual do you have that shows the run indicator lamp
> (and/or Hobbs meter) of the remote panel wiring connected anywhere but pin
> 6?
>
> From the 4k ops and parts manual, page 11, figure 10:
>
> http://www.gmcmhphotos.com/photos/data/10/Onan_Control_Board_Schematic.jpg
>
> And page 8, figure 6:
>
> http://www.gmcmhphotos.com/photos/data/10/medium/Onan_
> Remote_Control_Switch.jpg
>
> And page 9, figure 8:
>
> http://www.gmcmhphotos.com/photos/data/10/medium/Onan_
> Deluxe_Remote_Control.jpg
>
> --
> 73 23' Sequoia 4 Sale
> 73 23' CanyonLands Parts Unit 4 Sale
> Upper Alabama
> "Every day I become more convinced that I am the only person left on the
> planet that recognizes nonsense for what it is."
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
Re: [GMCnet] Onan Remote Wiring [message #318276 is a reply to message #318242] Wed, 31 May 2017 12:41 Go to previous messageGo to next message
Carl S. is currently offline  Carl S.   United States
Messages: 4186
Registered: January 2009
Location: Tucson, AZ.
Karma: 13
Senior Member

Thanks everyone. I DID connect the running indicator light/Hobbs meter wire to the #6 pin on the control board as suggested. Everything works as it should.

Carl Stouffer '75 ex Palm Beach Tucson, AZ. Chuck Aulgur Reaction Arm Disc Brakes, Quadrabags, 3.70 LSD final drive, Lenzi knuckles/hubs, Dodge Truck 16" X 8" front wheels, Rear American Eagles, Solar battery charging. GMCSJ and GMCMI member
Re: [GMCnet] Onan Remote Wiring [message #318289 is a reply to message #318242] Wed, 31 May 2017 20:11 Go to previous message
Ken Henderson is currently offline  Ken Henderson   United States
Messages: 8726
Registered: March 2004
Location: Americus, GA
Karma: 9
Senior Member
OK, here's the answer to our conflict:

There are at least two Onan service manuals, with the ID numbers 6A73 and
10A73. They're posted here:
https://drive.google.com/drive/folders/0B3XquSIYjDleMTBNZ3hoQTJnYU0?usp=sharing

Also posted there, extracted from each of the manuals, are the
corresponding wiring diagrams. If you examine them closely, in light of
our recent conversations, you'll see that on the 6A73 schematic pins 6 and
9 are directly connected to each other and to the ignition coil, the fuel
solenoid, and the fuel pump. On the 10A73 schematic, pin 6 has been moved
to the junction of CR5, CR7, and R2.

It's obvious that the purpose of the change was to provide the isolation
some of you want of the RTM from the starter. Too bad Onan never announced
(or, more likely, we late-comers missed) the change. I suspect the 10A73
configuration is what most of us have -- 'tho' I have no evidence to
support that.

My modified wiring diagram was obviously taken from the 10A73 version --
despite my having rather badly screwed up the flywheel alternator
connection. I'll get around to fixing that soon.

Ken H.


On Tue, May 30, 2017 at 9:05 PM, Ken Henderson
wrote:

> Ah Ha! We've found it! I don't have time now to do the research to sort
> it all out, but there ARE differences in the manuals!
>
> The schematic you show IS different than that I referred to. And yours is
> obviously the one from which I drew "my" version because it shows (6)
> connected as I just "corrected" to agree with the other schematic. :-(
>
> I'll try to get back into this tomorrow and identify which manuals have
> which versions.
>
> Ken H.
>
>
> On Tue, May 30, 2017 at 8:47 PM, A. wrote:
>
>> Ken Henderson wrote on Tue, 30 May 2017 18:56
>>> A.,
>>> I don't know what Onan schematic you're looking at, 'cause the one I
>> see in the Onan manual, page 30, shows pins 6 & 9 directly connected to the
>>> fuel solenoid, the fuel pump, and the coil. I posted a very roughly
>> hi-lited copy at:
>>> https://drive.google.com/file/d/0B3XquSIYjDleZjRiOEwyN1NxeXM
>> /view?usp=sharing
>>>
>>> Have you found a different version?
>>>
>>> Ken H.
>>
>> Apparently. I Have a 6k manual, but the resolution is too poor to make
>> out the pin numbers. What manual do you have that shows the run indicator
>> lamp
>> (and/or Hobbs meter) of the remote panel wiring connected anywhere but
>> pin 6?
>>
>> From the 4k ops and parts manual, page 11, figure 10:
>>
>> http://www.gmcmhphotos.com/photos/data/10/Onan_Control_Board
>> _Schematic.jpg
>>
>> And page 8, figure 6:
>>
>> http://www.gmcmhphotos.com/photos/data/10/medium/Onan_Remote
>> _Control_Switch.jpg
>>
>> And page 9, figure 8:
>>
>> http://www.gmcmhphotos.com/photos/data/10/medium/Onan_Deluxe
>> _Remote_Control.jpg
>>
>> --
>>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
Previous Topic: Re: [GMCnet] Questions about Daytime Running Lamps DRL
Next Topic: [GMCnet] Questions about Daytime Running Lamps DRL
Goto Forum:
  


Current Time: Mon Dec 02 14:04:51 CST 2024

Total time taken to generate the page: 0.01589 seconds